Helpful Information:

Solution:

Switching the Connection Method to Wireless LAN

1. Press [ ] (Menu).

2. Select <Network Settings> with [ ] or [ ], and then press [OK].


The screen below is displayed for approximately 5 seconds. (You do not need to turn the machine OFF/ON in this step.)

3. Select <Select Wired/Wireless LAN> using [ ] or [ ], and then press [OK].

4. Select <Wireless LAN> using [ ] or [ ], and then press [OK].

5. Turns the machine OFF/ON when the following screen disappears.

It is necessary to turn the machine OFF/ON to activate the settings.
Turn OFF the machine and wait for at least 10 seconds before turning it back ON.
MF8380Cdw/MF8360Cdn/MF8340Cdn

MF8080Cw/MF8040Cn

Setting the Machine Using WPS (Push Button Mode)

Press the WPS button on your wireless LAN routers and/or access points for connection.

1. Press [ ] (Menu).

2. Select <Network Settings> using [ ] or [ ], and then press [OK].

When the system manager ID and system manager PIN are specified, use the numeric keys to enter the ID and number, and then press [ ] (Log In/Out).

3. Select <Wireless LAN Settings> using [ ] or [ ], and then press [OK].

4. Press [OK].

5. Select <WPS Push Button Mode> using [ ] or [ ], and then press [OK].

6. Select <Yes> using [ ], and then press [OK].

7. Within two minutes, press and hold the WPS button on the wireless LAN router or access point for approximately 5 seconds.

* If "Cannot find Access Point" appears, press [OK] to close the screen and follow the procedure again from Step 5.

8. Make sure the Wi-Fi indicator blinks.

When the wireless LAN router or access point is detected, the Wi-Fi indicator blinks.

The screen below is displayed for approximately 2 seconds, and then the Wi-Fi indicator lights up.

* If an error message appears, press [OK] to close the screen and follow the procedure again from Step 5. If you cannot detect the access point after retrying, see "Onscreen Messages" in the e-Manual.

9. Wait until the machine sets the IP address automatically (approx. 2 min).

If you want to set the IP address manually, see "Setting the IP Address."

Checking the Wireless LAN Setting is Completed

1. Press [ ] (Status Monitor/Cancel).

2. Select <Network Information> using [ ] or [ ], and then press [OK].

3. Select your network type.

To check the IPv4 address settings

• Select <IPv4> using [ ] or [ ], and then press [OK].

• Select the setting to check using [ ] or [ ], and then press [OK].

To check the IPv6 address settings

• Select <IPv6> using [ ] or [ ], and then press [OK].

• Select the setting to check using [ ] or [ ], and then press [OK].

4. Take note of the IP address.

IPv4

IPv6

5. Press [ ] (Status Monitor/Cancel) to close the screen.

6. Start the Web browser of a computer which is connected to a network.

7. Enter "http://IP address of the machine/" in the address field and press the [ENTER] key on the keyboard.

The <IP address of the machine> is the address noted in step 4 above.
Example: http://192.168.0.215/

8. Check that the screen of the Remote UI is displayed.